Simpson Evolution 808 stove made in Australia in 2000. All stoves made in Australia by Electrolux (Westinghouse, Simpson, Chef, and so forth) in the most recent decade or so utilize a fundamentally the same as outline so this guideline will suit. I was part of the way through cooking a pizza when my security switch stumbled off the ability to my home. I flicked it back on and all appeared to be fine ... until I returned to keep an eye on my pizza. The broiler temp had dropped to nothing despite the fact that the fan and stove light were all the while working. So instead of purchase another broiler I figured I could alter it. All I required was a phillips screw driver, a little hex attachment drive and a 8mm spanner. Step 1 1. Kill the mains at the switch board. There may be a switch close to the broiler or stove as well, kill that also. Watch that the power is off! 2. Expel the screws holding the stove to the organizers. Mine was held in by 4 timber screws on the edge. 3. Slide the stove out of the divider. I utilized a little table to bolster it. Step 2 4. Evacuate the hex drive screws that hold the top cover on. 5. Utilizing a trusted multimeter CHECK THAT POWER IS OFF! There are presently uncovered power terminals. Step 3 6. Fix the supply control terminals and expel the link. I taped mine up. 7. Expel the back cover - more hex screws. 8. Pull the spade terminals off the radiator component. Step 4 9. Inside the stove evacuate the racks and side racks. They pop off the divider. 10. Pull the back fan shield towards you. It ought to pop out at the finish and afterward lift off 2 little tabs. Step 5 11. Expel the phillips screw at the base of the radiator component. 12. Expel the 2 spring cuts. 13. The component can now slide down and towards you. 14. Supplant the component and set up everything back together in turn around request. Tips: Run the stove for some time since mine stank when I turned it on. Trust that makes a difference. Visit our website https://ringhotwater.com.au/ for more information.